Skip to content

Perlegear PGMF24B full-motion TV wall mount, 32–65" review

A stated 60 kg on a single arm with two separate tilt adjusters — the heaviest capacity on this shelf outside the premium bracket.

The bottom line The strongest arm on this shelf, with the one figure that governs its demand on the wall left unpublished.

The capacity

60 kg stated — the highest among the moving mounts here, and unusual on a single-joint arm. The maker describes what it did to get there: a thicker arm, thicker wall plates, solid tubular columns. Describing the construction rather than asserting the result is worth something.

The adjustment

−15° to +5°, set through two knobs — one folding, one geared. The geared one is the reason to care: adjusting tilt with a television already hanging is a job the mount either helps with or does not.

The reach

±90° swivel on a single joint. A single-joint arm reaches less far than a double, and it has one fewer place to develop play over years.

The figure that is missing

Maximum extension. On an articulating mount, the turning moment at the fixings is the weight multiplied by the distance it hangs from the wall. Without the distance, the 60 kg figure cannot be translated into what the wall will see.

The VESA floor

It starts at 200×100. Small televisions using 100×100 fall below the range — a size rating of 32 inches does not mean every 32-inch set will bolt on.

Availability

On sale from 42 € to 64 € on the German, British, French, Italian and Spanish Amazon stores at the time of checking.

Not found on the American Amazon store, where the buy link falls back to a local search rather than to a page that does not exist.

Prices and availability are what Keepa reported on the date this page was updated; both move.

Prices quoted in this text were read on 4 September 2026. The live price is at the top of the page.

What we like, and what we don't

Strengths

  • A stated 60 kg, the highest capacity among the moving mounts here bar none
  • Two separate tilt adjusters, so the angle can be set precisely rather than approximately
  • ±90° swivel on a single joint, which gives reach without a second elbow
  • The maker describes the reinforcement rather than only asserting strength

Compromises

  • The maximum extension is not stated, which on an arm is the figure that matters to the wall
  • The VESA minimum starts at 200×100, so small sets with 100×100 patterns are out
  • A stated 60 kg on an arm makes the wall the limiting factor by a wide margin

Specifications

Screen size32–65 inches (81–165 cm) — stated
VESA rangeFrom 200×100 and 200×200 upward — stated
Stated load capacity60 kg — the mount, not the wall
Tilt−15° to +5°, via a folding knob and a geared knob — stated
Swivel±90° — stated
ArmSingle-joint design, arm stated 30% thicker with thicker wall plates and solid tubular columns
Amazon referenceB0DX6XDFS8 (same reference on 5 Amazon marketplaces)
EAN0840478807868

Questions people actually ask

Why two tilt adjusters?

One sets the angle roughly and the other refines it. On a mount that has to be adjusted with a television already hanging on it, a geared adjuster is the difference between setting an angle and fighting one.

Is 60 kg on an arm realistic?

For the arm as tested, that is the maker's figure. What reaches the wall is that weight multiplied by how far out the screen sits, and this listing does not publish the extension. On any articulating mount, the wall is the part to be sure of.